hairConstraint

Go to: Related nodes. Attributes.

This node can be used to constrain points in a hair simulation.

Related nodes

hairSystem

Attributes (8)

constraintMethod, curveIndices, glueStrength, outPin, pointMethod, stiffness, uDistance, uParameter

Long name (short name)	Type	Default	Flags
constraintMethod (cm)	enum	1
This specifies how the hairpin constrains the hair. If off then no constraint is computed. HairToPin locks attaches the hair to the pin, such that moving the pin will drag along the hair. HairToHair will constrain the hair vertices at the pin location to other hair vertices. The attachments are created at the startframe and are based on the start position of the hairs. The closest points along each hair to the pin are the ones that get the constraint.
curveIndices (cin)	integer	0
HairSystem node index values used to determine curves affected by this constraint.
glueStrength (gst)	double	1.0
Strength of glue holding the pin. A value less than one can allow the constraint to break during the simulation if the tension exceeds the strength.
outPin (opn)	hairPin	NULL
output hairpin data for use by hairSystemShape node
pointMethod (pmt)	enum	0
This specifies how the point to constrain along each hair is determined. Nearest constrains the closest point on each curve to the constraint at the start frame. U Parameter constrains the point at that U value along the curve. The end of the curve is 1.0 . U Distance constrains the points at that distance in worldspace from the start of the curve.
stiffness (stf)	double	0.5
The stiffness of the spring attachments created by the hair pin.
uDistance (udi)	double	1.0
If the point method is uDistance this determines the distance from the curve start that determines the point along curves to constrain.
uParameter (upr)	double	1.0
If the point method is uParameter this determines the u value used in determining the point along curves to constrain.