Constrains the angle between line or polyline segments, the angle swept out by an arc or a polyline arc segment, or the angle between three points on objects.
This command is equivalent to the Angular option in DIMCONSTRAINT.
When you enter or edit an angle value that is either negative or is greater than 360 degrees, the number entered is stored for the expression (for example, 390), but the value displayed is based on the formatting of the units (for example, 30 if decimal degrees).
When an expression with variables evaluates to greater than 360 or less than -360, the constraint value is displayed in the Parameters Manager based on the units of the drawing.
The following table outlines the valid constraint objects and points:
|
Valid Objects or Points |
Characteristics |
|---|---|
|
Pair of lines Pair of polyline segment Three constraint points Arc |
|
The following prompts are displayed.
Line
Selects a line object.
- First Line
-
Specifies the first line to be constrained.
- Second Line
-
Specifies the second line to be constrained.
- Dimension Line Location
-
Determines where the dimension line is located on the constrained object.
Arc
Selects an arc and constrains the angle.
- Dimension Line Location
-
Specify dimension line location.
3Point
Selects three valid constraint points on the object.
- Angle Vertex
-
Specifies the angle vertex, which is at the centerpoint of the constraint.
- First Angle Constraint Point
-
Specifies the first angle endpoint of the arc.
- Second Angle Constraint Point
-
Specifies the second angle endpoint of the arc.
- Dimension Line Location
-
Specify Dimension Line Location