Draw arched slot

Three Point Arc Slot

1. On the ribbon Sketch tab Draw panel, click Three Point Arc Slot .
2. Click in the graphic window to place the start point of the center arc.
3. Move the cursor, and click to place the end point of the center arc.

   If appropriate, enter the distance or angle in the edit field.

4. Move the cursor, and click to the third point of the center arc.

   Alternatively, enter the arc radius in the edit field.

5. Move the cursor, and click to specify width of the slot. Alternatively:
   • Enter the width in the edit field.
   • Right-click, and click Radius. Then enter the radius of the slot arc.
6. To end, press Esc or click another command.

Center Point Arc Slot

1. On the ribbon Sketch tab Draw panel, click Center Point Arc Slot .
2. Click in the graphic window to place the center point of the slot.
3. Move the cursor, and click to place the start point of the center arc.

   If appropriate, enter the distance or angle.

4. Move the cursor, and click to place the end point of the center arc.

   Alternatively, enter the angle.

5. Move the cursor, and click to specify width of the slot. Alternatively:
   • Enter the width in the edit field.
   • Right-click, and click Radius. Then enter the radius of the slot arc.
6. To end, press Esc or click another command.