Load Full and Load Express

Load Full loads all component data and all commands are available. Load Express provides significantly faster (3-5x) file open times for large assemblies, but some commands are not available. If Express is enabled in the Assembly Application Options, enhanced display data is saved in the top level assembly (.iam) file. The extra data enables Inventor to open the assembly faster.

Enable Express mode

Enable Express mode and set the default open behavior in Application Options.
  1. On the ribbon, click Tools tab Options panel Application Options
  2. Click the Assembly tab.
  3. Click Enable Express mode.

Open and save each assembly file with the option enabled to store the display data required to use Express mode.

Because some commands are not available in Express mode, you can set the default open behavior based on a unique file threshold value. This allows you to open very large assemblies in Express mode, while smaller or less complex assemblies fully open.

To set the threshold value in Application Options:
  1. Click the Assembly tab.
  2. Set the numeric value for Open Express when referenced unique files exceeds. Choose a number that represents meaningful file open performance improvement for assembly models. File open times are based on factors such as number of occurrences, complexity of model geometry, and system hardware specifications.
Tip: To revert the assembly file back to the original size, close all documents and then clear the Enable Express mode workflows check box. The next time you open and save the assembly file, the express data is removed.

Enter Express mode

After you enable Express mode and save an assembly, the threshold value is used to set the default open mode. Assemblies that meet or exceed the threshold number open by default in Express mode.

Use File Open Options

You can also use the File Open Options to determine whether to open the assembly in Express mode. Clear the check box to fully open the assembly.
Note: If the Open Express check box is not available, the assembly has not been saved with the necessary display data and will fully open.

Express mode commands

Some commands are not available in Express. If a required command is not available, Load Full.

Parent topic: Large Assemblies