The Quality Prediction result indicates this area of the part can be difficult to fill with plastic. The pressure drop is too high at the point you selected, compared to the maximum injection pressure.
The pressure drop is the drop in pressure from the initial injection pressure to the pressure recorded at the moment the part was filled, for the entire model.
The lower the pressure drop values recorded, the more likely the part fills completely.
If the pressure drop is greater than 80% of the injection pressure, there can be filling problems. The part can short shot.
When the pressure drop is high, there are some ways you can improve the moldability of the part:
The pressure drop is greater than 80% of the set maximum injection pressure. To improve the confidence of this part filling, increase the injection pressure slightly to compensate for the high-pressure drop through the cavity.
If the part consists of a complex and thin geometry, filling difficulties can require high injection pressure to complete the filling. If you cannot alter injection pressure, you can change the part geometry.
You can change the recommended processing conditions. To improve this result, you could increase the melt temperature of the current material.
A material with a higher melt flow rate, requires less injection pressure to fill the part.
To improve the likelihood that all sections of a part fill, move the polymer injection locations closer to the problem area. Also, add more injection points.