The Import Destination Options specify Autodesk Inventor file options, file location, and templates to use when translating a Mechanical Desktop file into Autodesk Inventor files. Click Finish to accept defaults or set individual options.
| Access: |
Click |
|
Assembly Options |
Accept Referenced components only or select All Component Definitions. |
|
Part Options |
Accept As Features and then specify how to translate parts with unsupported features. Optionally, select Translate Body Only. |
|
Drawings with Views Options |
Accept Selected and External Files or select Selected File Only. |
|
Mechanical Symbols |
Specifies method to map symbols. Map all to single view sketch imports all symbols as simple geometry into one single sketch. Map to individual sketch symbols imports symbols as simple geometry into discrete sketch symbols. Select the Native FCFs, Surface Textures and Datum IDs check box to import feature control frames, surface textures, and datum IDs as native Inventor symbols. |
|
Output Options |
Specifies what to do if a duplicate output file is found. Accept Overwrite or select Use Existing File (to retain existing data). |
|
Import File Units |
Select Detected Units or Specify Units. Detected Units is based on the block insert units (INSUNITS) system variable in the DWG file. If this value is unitless or set to an unsupported unit, the value of the MEASUREMENT variable (inch or mm) is used. Specify Units specifies conversion units from the list. |
|
Templates |
Specifies the default templates you accept, or templates you browse to and select. |
|
Destination Folder |
Specifies the default destination folder you accept, or a different folder you browse to. |
|
Save Configuration |
Specifies a configuration you browse to and select, if needed. |