You can redefine a splice to a new location on the existing wire or segment. You can also redefine a splice on a segment to a location that is off that segment. If the new location is on a different wire or segment:
- the new wire or segment is split
- the existing segment is healed
- any wires attached to the splice are unrouted
- redundant wires (wires that share a common point when spliced) are deleted
Once a wire is spliced, you cannot redefine the splice to a location off the wire. You can only delete it.
- In an active harness assembly, right-click a splice from the browser or graphics window, and then select Redefine Splice from the context menu.
- Optionally, right-click to edit the offset, select Edit Offset from the context menu, and then enter an offset value (with or without a unit). If no unit is specified the default unit setting is used.
- Click OK.
- In the graphics window, select the new location for the splice:
- To associate the splice with existing geometry, select a vertex, work point, sketch point, or center points on circular components.
- To offset the splice at a specified distance, select a face.
- To create a non associative splice without an offset, select a work plane, a work axis, or anywhere along a wire or segment.
- Right-click and select Finish Edit.
The splice is redefined and the splice and any connected wires recompute.