Calculates fatigue loaded weld joints where static calculation is not sufficient.
|
Access: |
Ribbon:
Environments tab
Convert panel
Fillet Weld Calculator (Plane)
, and then click the Fatigue Calculation tab. |
Loads
Enter the loading parameters.
|
Endurance Limit Determination |
|
|
Sets the parameters. See the Weld Joint Endurance Limit Determination chapter in Engineer's Handbook for more information. |
|
|
Basic Endurance Limit of Material |
Specifies either the estimated value (predefined by the calculator) or a value according to the results of the material tests you enter. |
|
Surface Factor |
Implies that the fatigue strength is growing in relation to the increasing quality. Click the arrow to set the value in the Surface Factor dialog box. |
|
Size Factor |
The value is lower than 1 for joints loaded with reversed bend or torsion (shear). If the joint is loaded with reversed tension, pressure its value has no effect on the fatigue strength. |
|
Reliability Factor |
Displays a calculated value. The value decreases in relation to the growth of the reliability requirement. |
|
Modified Factor of Stress Concentration |
Displays a reciprocal value to the Fatigue-Strength Reduction Factor. |
|
Operating Temperature Factor |
Depends on the used material. The endurance limit of the commonly used structural steels working in the approximate range between -20 and 200°C can be set as 1 (it does not depend much on the temperature). |
|
Factor of Miscellaneous Effects |
Includes all other effects that can reduce or increase the fatigue strength of the weld joint (for example the influence of corrosion). |
|
Fatigue Strength Calculation Method |
|
|
See the Endurance Limit for Weld Joints and Fatigue Strength of Weld Joints chapters in Engineer's Handbook to find more information and calculation formulas. |
|
|
Calculation Parameters |
|
|
Sets the parameters for calculation process. |
|
|
Dynamic Stroke Factor |
Specifies a value you enter or select in the Recommended values of dynamic stroke factor dialog box. Note: See the Fatigue Strength of Weld Joint chapter in Engineer's Handbook for more information.
|
|
Life in Thousands of Deflections |
Specifies a value you select from the list. Instructions for selection can be found in the Endurance Limit in the Scope of Timed Strength chapter of the Engineer's Handbook. |
|
Required Safety Degree |
Sets the ratio of fatigue strength and the calculated stress of the weld joint. Enter the value, or click the arrow to select the value in the Safety Factor of Fatigue-Loaded Weld Joint dialog box. Note: See the Safety Factor of Fatigue Loaded Weld Joint chapter of the Engineer's Handbook for more information.
|
Calculation of Fatigue Loaded Weld According to the CSN Standard
The Fatigue Loading tab changes if calculation according to CSN is applied.
The section of the Check of Basic Material replaces the Endurance Limit Determination. It contains parameters needed within the calculation for checking the strength in a part of weldment not affected by the weld.
The section of Calculation Parameters contains some additional parameters.
Results
Displays the calculated values and the joint strength check.
Summary of Messages area
Displays the reports about calculation. To open the Summary of Messages area at the bottom of the tab, double-click the double line at the bottom of the tabs or click the chevron.