Sets parameters for calculation of a plug and groove weld joint.
|
Access: |
Ribbon: Environments tab  Convert panel Plug/Groove Weld Calculator  .
|
|
Calculation of Statically Loaded Weld |
|
|
Specifies the Standard Calculation Procedure and Method of Comparative Stresses. Selects a calculation method for statically loaded weld joints. Both methods calculate resultant stresses in a similar way, but the evaluation of results for the strength check is different. See the Engineer's Handbook for used methods of weld joint calculations. |
|
|
Standard Calculation Procedure |
Checks joint strength by direct comparison of calculated normal, shear, or resulting reduced stress with the allowable stress by using a standard calculation procedure. See the Engineer's Handbookfor calculation formulas. |
|
Method of Comparative Stresses |
Compares allowable stress with auxiliary comparative stress, which is determined from the calculated partial stresses by using conversion factors of the weld joint when the strength check is carried out with this method. See the Engineer's Handbook for calculation formulas. |
Loads
Enter the acting force.
Dimensions
Summarizes all parameters necessary for definition of the weld geometry. Displayed options depend on the Weld Design selected type.
|
Joint Material and Properties |
|
|
Opens the Material Database where you select a material. Edit the properties of the material, if needed. |
|
|
Yield Strength |
Displays the maximum stress that can be applied without permanent deformation of the test specimen. The value is automatically modified according to the selected material. When you edit the value, the selected material is changed to User. |
|
Safety Factor |
Enter the value or click the arrow to set the value in the Safety Factor dialog box. |
Weld Design
Diagrammatic pictures of weld design are changed according to the selected weld type. Choose the corresponding weld design.
Results
Displays the calculated values and the weld strength check.
Summary of Messages area
Displays the reports about calculation. To open the Summary of Messages area at the bottom of the tab, double-click the double line at the bottom of the tabs or click the chevron.