To edit sketched route segments, use the General Dimension or Parameters commands to modify the normal sketched dimensions . They can also be edited in place by double-clicking. As linear and angular dimensions can be placed between the route sketch and reference geometry, use the Include Geometry command to introduce reference geometry as you need.
Note: A
driven dimension
cannot be manually edited until it is switched to normal sketched dimension.
- Activate the route containing the sketched route segment.
- Optionally, include external geometry to the route sketch.
- In the graphics window, ensure a dimension is selected rather than route sketch. The following symbol should be attached to the cursor.
- To modify the linear dimension, bend radius, or included angle, do any of the following:
On the ribbon, click
Route tab
Constrain panel
Dimension
. - Double-click the dimension and enter a new value in the Edit Dimension dialog box. Click the green check mark to apply the change.
On the ribbon, click
Route tab
Parameters panel
Parameters
and edit the model parameter for the appropriate route segment or bend radius. To verify which model parameter is used to designate the dimension, right-click the dimension and select Dimension Properties.
- In the graphics window, right-click and select Done, or press ESC to quit the command.