Results Summary

A result summary showing the analysis inputs and the results of each phase of the analysis or analysis sequence is generated for each analysis that is performed.

Select Summary in the Study Tasks pane to view this summary.

Note: Results summaries are included by default in results files exported from Autodesk Simulation Moldflow Adviser.

Summary

All of the inputs that have been specified for the analysis are listed in the General tab of the Summary pane, and this section is used to verify that the inputs are correct. This summary contains the following information, depending on the analysis that is being run:

Solver parameters
Material data
Process settings
Model details

The Mold tab records the following information:

Mold dimensions
Mold material
Mold plate dimensions
Mold offsets

The Runner System tab records the following information:

Sprue dimensions
Runner dimensions
Gate dimensions

The Cooling System tab records the following information:

Cooling circuit dimensions
Coolant information

The Fill tab records the following results:

Actual filling time
Actual Injection pressure
Clamp force area
Max. clamp force during filling
Velocity/pressure switch-over at % volume
Velocity/pressure switch-over at time
Estimated cycle time
Total part weight at the end of filling
Shot volume
Cavity volume
Runner system volume

The Pack tab records the following results:

Maximum clamp force during cycle
Max. wall shear stress
Total part weight
Cooling time
Cycle time

The Cooling Quality tab records the following results:

Maximum and minimum temperature variance
Maximum and minimum cooling time variance

The Cool tab records the following results:

Maximum temperature, part
Minimum temperature, part
Average temperature, part
Mold exterior temperature

The Cost Adviser displays the following results:

Total cost
Total cost per shot
Material cost
Mold cost
Molding cost
Post-molding cost
Cost breakdown

Tip: Click Set up Cost Adviser to set up the Cost Adviser.