** WARNING 701050 ** Target mold temperature not satisfied. Switching to frozen mode.
The Cooling time setting in the process settings is set to Automatic. The aim of an automatic analysis is to calculate a cycle time that ensures that the average mold temperature of the part is within 2 degrees of the selected target mold temperature. In this case the coolant temperatures selected are too cold relative to the target mold temperature. This means that the time required to reach the target mold temperature is too quick with regard to filling time and clamp open time that are fixed. If this is the case, then the automatic analysis then aims to calculate a cooling time based on the specified frozen percentage.
Increase the coolant inlet temperatures to within approximately 10 degrees of the target mold temperature. This warning can be ignored if the percentage of the part that is frozen at ejection is adequate.