** ERROR 313140 ** Rapid heating and cooling solver does not support the "averaged within cycle" option.
The Averaged within cycle mold temperature option has been selected in the Cool (FEM) analysis solver parameters, but this option is not supported for rapid mold heating and cooling analysis.
Averaged within cycle assumes that after a few cycles the mold will reach steady state conditions and the temperature variation in the mold, from this point onwards, will be the same. If subsequent cycles exhibit different behavior, then Averaged within cycle is not a valid option.
If you have a heater with thermocouple control, you should run the Transient from production startup analysis, set the number of iterations to run, and study the temperature behavior over multiple cycles.