The Temperature, mold (transient) result shows the temperature of the mold as it changes over the duration of the cycle.
Use this result to find localized hot or cold spots, and determine whether they will affect cycle time and part warpage. If there are hot or cool spots, you may need to adjust the cooling channels, or coolant temperature. Use a cutting plane to investigate hot or cold spots inside the part.
The minimum and maximum mold temperature should be within 10°C of the target temperature for amorphous materials and within 5ºC for semi-crystalline materials. This guideline may be difficult to achieve for most molds, but should be the target of the Cool analysis. The narrower the temperature variation over the mold face, the less likely the mold temperature variation will contribute to warpage or an extended cycle time. Cooling channel placement and the thermal conductivity of the mold will affect the temperature variations.
The Temperature, mold (transient) result will typically be between 10ºC and 30ºC above the coolant inlet temperature. If an automatic Injection + Packing + Cooling time is used, a coolant temperature too close to the target temperature will significantly extend the predicted cycle time.
When viewing the Temperature, mold (transient) result, watch for the following.