Fill+Pack analysis DOE results

The type of result depends on the experiment type selected.

The following table lists the graphical results generated for a DOE Fill+Pack analysis and indicates whether each result is supported for the following analysis technologies:

• Midplane
• Dual Domain
• 3D

The results for the Fill+Pack analyses use the initial conditions specified in the Process Settings Wizard.

Note: In addition to DOE plots, which are appended with either XY Plot or Response Surface Plot, there are also DOE contour plots which are similar to the representations found in other result folders.

Plots .

These results are found in the Study Tasks pane under Optimization in the Results section. They include

• XY Plot for single variable analyses, and
• Response Surface Plots for multi-variable analyses.

Result	Analysis Technology
Bulk temperature at end of fill (DOE)
Maximum clamp force (DOE)
Injection pressure (DOE)
Shear stress (DOE)
Sink mark depth (DOE)
Temperature at flow front (DOE)
Cooling time (DOE)
Volumetric shrinkage at ejection (DOE)
Time at end of packing (DOE)
Cycle time (DOE)
Part weight/ mass (DOE)
Frozen layer fraction at end of fill (DOE)	reactive injection compression
Bulk conversion (DOE)	reactive molding, RTM or SRIM, underfill encapsulation

Quality information for influences experiments .

These results are found in the Analysis Log.

Result	Analysis Technology
Bulk temperature at end of fill
Maximum clamp force
Injection pressure
Shear stress
Sink mark depth
Temperature at flow front
Cooling time
Volumetric shrinkage at ejection
Time at end of packing
Cycle time
Part weight