Cool analysis for part optimization (Procedure)
The Cool analysis is used to analyze the flow of heat in the mold.
Topics in this section
Setting up a Cool analysis
The following table summarizes the setup tasks required to prepare a Cool analysis.
Running a Cool analysis
Run a Cool analysis to analyze the flow of heat in plastic injected molds.
Setting up an Averaged within cycle Cool analysis (Cool (FEM))
The following table summarizes the setup tasks required to prepare an
Averaged within cycle
cool analysis, using the
Cool (FEM)
solution.
Running an Averaged within cycle Cool analysis (Cool (FEM))
Parent topic:
Cool analysis for part optimization