Process Settings Wizard dialog-Controller B Settings

This dialog is used to specify process settings for Controller B in the Co-injection analysis:

To access this dialog, ensure that you have selected the Co-injection Molding process and an analysis sequence that includes Fill+Pack, click (Home tab > Molding Process Setup panel > Process Settings), then click Next to navigate to the Controller B Settings page of the Wizard.

Note: Some of the items listed below may not be available on the current dialog. This is dependent on the mesh type, molding process and analysis sequence selected.

General settings

Switch to the other controller by

Specifies when to switch from Controller A to Controller B, or from Controller B back to Controller A.

For the Co-injection molding process, this specifies when to switch from Controller A to Controller B, or from Controller B back to Controller A. Controller A controls Material A (usually the skin material) and Controller B controls Material B (usually the core material).

When the cavity volume reaches the specified percentage filled, control switches from the active controller to the other controller.

Enter a percentage value.

Controller B settings...

Click this button to display the advanced options for Controller B of the Co-injection process.