This page of the Process Settings Wizard, which can be accessed by clicking 
(), is used to specify the filling profile related process settings for the selected thermoset molding analysis sequence.
Note: Some of the items listed below may not be available on the current dialog. This is dependent on the mesh type, molding process and analysis sequence selected.
General settings
| Melt initial conversion | To specify the level of conversion, enter a value between -1 and 1 where:
|
| Curing time | The time taken for the thermoset material to become sufficiently cross-linked from heating to form a solid and freeze. |
| %Air mass | The percentage air mass value is used to simulate the effect of air in the molding compound on the polymer flow. In most cases, it can be set to 0 (zero). If this value is not zero, it will have an effect on the compressibility of the compound. |
| Ambient temperature | The ambient temperature should be set to the average ambient temperature at the site where the injection molding occurs. The default value for ambient temperature is 25°C (77°F). |
| Preconditioning analysis | Specify whether a preconditioning analysis should be performed. Preconditioning data are used to calculate the melt temperature. |
| Edit data | Click Edit Data to specify the preconditioning data |
| Advanced options | Displays the Reactive Molding Advanced Options dialog. |