To modify an instance property of a wall sweep, you change the value of the corresponding parameter, as described under Modifying Instance Properties.
Common instance properties for wall sweeps are described below.
| Name | Description |
|---|---|
| Constraints | |
| Offset From Wall | The distance from the wall face. |
| Level | The level of the wall sweep. This property only appears for horizontal wall sweeps. |
| Offset From Level | The wall sweep’s offset from the level. This property only appears for horizontal wall sweeps. |
| Dimensions | |
| Length | The length of the wall sweep. This is a read-only parameter. |
| Identity Data | |
| Comments | Enter comments for the wall sweep. |
| Mark | A value to designate the particular wall sweep. This value must be unique for each wall sweep in a project. Revit LT warns you if the number is already used but allows you to continue using it. You can see the warning using the Review Warnings tool. See Reviewing Warning Messages. |
| Phasing | |
| Phase Created | The phase when the wall sweep was created. |
| Phase Demolished | The phase when the wall sweep was demolished. |