Changing Routing Solutions

You can adjust the routing for the ductwork in an existing duct system.

1. Select at least two duct segments in the section where you want to adjust the routing or justification.
2. Click Multi-Select tabLayout tab Routing Solutions to activate tools for adjusting the routing for the ductwork.

   The following routing tools are activated on the Routing Solutions panel:

   • Control Points:  Add Control Point/ Remove Control Point

     Use the plus and minus buttons to add or remove vertex control points on duct segments. Click plus to add a point, then click a point on the duct to place the control point. Drag the point to adjust the shape of the duct routing. Transitions and fittings are automatically added to maintain connections.

     To remove a vertex, click the minus button and select the vertex that you want to remove.

   • Solution: 1 of n

     Use the arrow buttons to cycle through the proposed solutions.

3. Select a solution.
4. Adjust the routing, adding, removing, and dragging control points as necessary.
5. When you are satisfied with the routing, click Finish to apply the changes, or click Quit to dismiss the routing solutions editor without applying the changes.