Adding Floors

  1. Click (Floor: Architectural).

    Where is it?

    • Architecture tabBuild panelFloor drop-down (Floor: Architectural)
    • Structure tabStructure panelFloor drop-down (Floor: Architectural)
  2. Draw the floor boundaries, using one of the following methods:
    • Pick walls: By default, Pick Walls is active. If it is not active, click Modify | Create Floor Boundary tabDraw panel (Pick Walls). Select walls in the drawing area to use as floor boundaries.
    • Sketch boundaries: To sketch the profile of the floor, click Modify | Create Floor Boundary tabDraw panel, and select a sketching tool. See Sketching.

    The floor boundary must be a closed loop (profile). To create an opening in the floor, you can sketch another closed loop where you want the opening to appear.

  3. On the Options Bar, for Offset, specify an offset for the floor edges.
    Note: When you are using Pick Walls, select Extend into wall (to core) to measure the offset from the wall's core.
  4. Click Finish Edit Mode.