|
Constraints
|
| Vertical Profile Offset |
Moves the fascia or gutter above or below the edge on which you created it. For example, if you chose a horizontal roof edge, a fascia moves above or below that edge. |
| Horizontal Profile Offset |
Moves the fascia or gutter forward or backward from the edge on which you created it. |
|
Dimensions
|
| Length |
The actual length of the fascia or gutter. |
|
Identity Data
|
| Comments |
Comments about the roof fascia or gutter. |
| Mark |
A label applied to roof fascia or gutters. Usually a numeric value. This value must be unique for each roof fascia or gutter in a project. Revit issues a warning if the number is already used but allows you to continue using it. You can see the warning using the Review Warnings tool. See Reviewing Warning Messages. |
|
Phasing
|
| Phase Created |
The phase when the fascia or gutter was created. |
| Phase Demolished |
The phase when the fascia or gutter was demolished. |
|
Profile
|
| Angle |
Rotates the fascia or gutter to the desired angle. |