Adding a Cap

You can add caps to the open ends of duct and pipe content.

To add a cap to duct or pipe

To add a cap to a selected duct or pipe connector

To add a cap to a pipe or duct network

Revit uses the information specified in the routing preferences to determine which type of cap to add.

1. Select a duct or pipe segment, fitting, or accessory.
2. Click Modify|Ducts tab or Modify|Pipes tabEdit panel Cap Open Ends.

   Caps are added to all open ends of the selected element.

3. Right-click a connector and click Cap Open End.
4. Select a duct or piping network.

5. Click Modify|Ducts tab or Modify|Pipes tabEdit panel Cap Open Ends.

   Caps are added to all open ends of the selected content.

   The new caps are highlighted and a warning dialog displays the number of caps that were added. Use the dialog to remove caps or display details about where caps were added.

   Note: Caps are not added to takeoffs when you select a system. You must add a cap manually to any takeoffs.