A unique material characterization must be performed for each material used with Simulation Composite Analysis.
A stand-alone graphical user interface program called Composite Material Manager is installed with Simulation Composite Analysis. Composite Material Manager is used to characterize composite materials for use with the software. In this section, the steps to create a new composite material using Material Manager are described.
The properties [2] for the material used in this Tutorial, T700/2510, are given in the table below. We will be comparing OHT data at 75 °F so it is appropriate to use the RTD properties. Further, since the plate is loaded in tension, it is appropriate to use the tensile moduli for the characterization of the material.
It is common for datasheets to be missing a few of the properties required by Simulation Composite Analysis. In this case, our source of data is missing the intralaminar stiffness (ν23 or G23) and intralaminar strength (S23). S23 is not required but should be included in analyses where significant intralaminar stresses are present. When properties are missing they should be estimated based on similar materials and engineering judgment. Common values [3,4] for ν23 and S23 for carbon/epoxy unidirectional materials are 0.4 and 7.25 ksi.
Since the Simulation Composite Analysis algorithm decomposes the lamina-level stresses into fiber and matrix stresses, the fiber and matrix stiffnesses must also be provided. Accurate fiber and matrix properties are not as important as accurate lamina properties because they are iteratively tuned to match the specified lamina properties and volume fraction. Ideally, properties for the fiber and matrix would be known and entered. However, it is most often the case that the properties are not known and default properties should be entered. Composite Material Manager comes pre-populated with default fiber and matrix values for carbon/epoxy and glass/epoxy materials.