-PARTIALOAD (Command)

Loads additional geometry into a partially opened drawing from the command line.

The following prompts are displayed.

Specify first corner/opposite corner

Specifies rectangular area in the drawing area. Geometry from the defined view is loaded into the partially open drawing.

Layers to load

Loads geometry from the selected layers into the current drawing, including both model space and paper space geometry. To load geometry from multiple layers into the drawing, use a comma between layer names. If no layer geometry is specified, no layer geometry is loaded into the drawing, including geometry specified to load from a view.

Enter ? to display a list of layers available in the current drawing.

Unload all Xrefs on open?
Specifies whether xrefs are opened.
  • Yes. Does not load any external references into the drawing.
  • No. Loads all external references into the drawing.

View

Loads the geometry from the specified view into the current drawing.

View to load
Loads the geometry from the specified view into the partially open drawing.

Enter ? to display a list of model space views available in the specified drawing.

Layers to load

Loads geometry from the layer or layers you specify into the current drawing. To load geometry from multiple layers into the drawing, use a comma between layer names. If no layer geometry is specified, no layer geometry is loaded into the drawing, including geometry specified to load from a view.