Draws two parallel construction lines tangential to a specified circle.
Find
Summary
You can switch between a ray and an xline by specifying the construction line mode with the AMCONSTSWI command ( Find). A ray is a construction line extending to infinity in one direction only. An xline is a construction line extending to infinity in both directions.
List of Prompts
The following prompts are displayed.
Circle
Specify the circle the construction lines are tangential to.
Second point
Specifies the direction of the construction lines by specifying a point in the drawing area.
Angle
Specifies the direction the construction line by specifying the angle the construction line makes with the X axis. You can specify multiple angles (for multiple sets of parallel construction lines) separated by the | character.