You can zoom to a point name, point number, or a range of point numbers. You can run this command at the command line or as a transparent command from within another command.
To zoom to a point
To zoom to a list of points
To zoom to a range of points
- On the ribbon, click COGO Points contextual tab
COGO Point ToolsZoom To Point
. At the command line, enter the point name or number. - At the command line, enter ZTP and then enter point numbers separated by commas.
- At the command line, enter ZTP and then enter the range of points separated by a hyphen.
If a point is not in the current drawing a message is displayed at the command line. If a point included in a series of points is missing, then it is ignored and the location of all the other points will be used.
To transparently zoom to a point from within another command
- At the command line, enter ‘ZTP and then enter a point name, point number, or a range of point numbers.
After you run the command as a transparent command, the command line returns to the main command after a single zoom.
Note: At the command line you can enter a comma delimited list that contains both point numbers and point names.