Target Mapping Dialog Box

Use this dialog box to set and edit the mapping of targets in subassemblies to the names of actual objects in the drawing.

Corridor Name

Displays the name of the corridor.

Assembly Name

Displays the name of the assembly. If you are viewing the target for an entire corridor, for which there is more than one baseline, ‘**Varies**’ is displayed.

Start Station

Displays the start station for the assembly’s region or the start station on the corridor baseline. If you are viewing the target for the entire corridor for which there is more than one baseline, ‘**Varies**’ is displayed.

End Station

Displays the end station for the assembly’s region or the end station on the corridor baseline. If you are viewing the target for the entire corridor for which there is more than one baseline, ‘**Varies**’ is displayed.

The properties table contains the following columns:

Target

Lists targets that are required by the corridor’s subassemblies, categorized into three groups: Surfaces, Width Or Offset Targets, and Slope Or Elevation Targets.

Object Name

Opens either the Pick A Surface, Set Width Or Offset Target, Set Slope Or Elevation Target or Select Pipe Network dialog box, where you can select the AutoCAD Civil 3D object name to map to the subassembly target.

Note: To quickly set all surface targets to the same surface object, click <Click Here To Set All> next to the Surfaces collection and select the surface object.
Subassembly

Displays the name of the subassembly that requires the target.

Assembly Group

Displays the name of the assembly group.