Reorder sequence of bends in flat pattern

1. On the ribbon, click Flat Pattern tab Manage panel Bend Order Annotation. The Bend Order glyphs appear.
2. Right-click, and then click Sequential Reorder.
3. Click the Bend Order glyph to number 1 in the sequence. The selected glyph changes to an override glyph, and the remaining glyphs are renumbered.
4. Click the Bend Order glyph that you want to be next in the specified sequence. Repeat this step until you have the required bend sequence.
5. When finished, right-click and then click Done.). The Bend Order Annotation command is still active,. Select any glyph to display the Bend Order Edit dialog box, where you can enter an individual override.
6. When you have completed edits to the bend order sequence, right-click and select Finish Bend Order. All Bend Order glyphs are removed from display.

If the selected start glyph is in an edited state, the start bend order number does not change, and its state remains as edited. All the bend centerlines encountered along the traversal from the start to end positions, including the end glyph, are set to edited during the process.