Specifies the thread boss parameters of the Boss feature.
- Access
- On the ribbon, click 3D Model tab
Show Panel icon 
. Select Plastic Part panel to display the Plastic Part panel, and then select Boss 
, and click the Thread tab.
- Thread boss diameter
-
- Thread boss hole diameter
-
- Thread boss inner draft angle
-
- Thread boss outer draft angle
-
The thread boss offers three hole types (hole check mark on):
- Depth
- Enter the hole depth.
- Full Depth
- The hole is automatically extended to the internal wall face. The best practice is to avoid sink marks in molded plastic parts.
- Through
- The hole cuts the entire part.
If the hole check mark is off, the thread boss can model an ejector pin.