Refold sketch with sheet metal feature

Refold one or more sheet metal bends or rolls relative to a reference face.

Use this procedure on a folded sheet metal model that has:

• At least one Unfold feature in the unfolded state.
• At least one sketch created on the face of an unfolded feature.

1. On the ribbon, click Sheet Metal tab Modify panel Refold .
2. Click a face or plane to use as the Refold reference.
3. Click individual highlighted bends or rolls to refold. To select all highlighted geometry, click Add All Bends, and then use CTRL+click to remove bends or rolls from the selection.
4. Preview the refolded state, and add or delete bends or rolls as necessary.
5. To select sketches, click the Sketches arrow, and then select any unconsumed sketches to refold.
6. To control the display of the parent sketch following the refold, check or clear Parent is Visible.
7. Click OK.

   A Refold feature is added to your sheet metal part browser.