Individually override bend order in flat pattern

  1. On the ribbon, click Flat Pattern tab Manage panel Bend Order Annotation. The Bend Order glyphs display.
  2. Click any individual Bend Order glyph.
  3. In the Bend Order Edit dialog box, in Bend Number, enter a number to replace the displayed sequence number.

    If you want the selected bend to share a sequence number with an existing bend, click Duplicate Number.

  4. Click OK.
  5. When the bend order sequence is acceptable, right-click and then click Finish Bend Order. All Bend Order glyphs are removed from display.

If you change a higher number in the sequence to a lower number, all of the numbers that are affected by the change resequence by incrementing. If you change a lower number in the sequence to a higher number, all of the numbers that are affected by the change resequence by decrementing.

Tip: For a few bends in a sequence, apply individual overrides. For the entire bend sequence, use either Directed or Sequential Reorder.