Edit bend in sheet metal part

Edit bends in sheet metal parts and features like flanges and countour flanges.

Note: Bends that are previously edited display a Bend Edit glyph with a dark green background and an edit pencil over the bend icon. You can edit these bends.

1. Decide which bend to edit. As your cursor moves over each Bend Edit glyph the glyph background highlights (the highlight color depends upon the active color scheme but is typically red).
2. Click the Bend Edit glyph for your selected bend. The background color of the selected glyph changes to the selection color in the active color scheme and the Bend Edit dialog box displays.
3. On the drop-down list for Type, click Width Extents, and modify the width extent parameters as required by width type you select:

   Edge

   Reset an entire edge that was previously defined with Width, Offset, or From/To.

   Width

   Click either Centered or Offset, and enter a value.

   Offset

   Select face (vertex, work plane, or work point to define Offset 1 and Offset 2 ,and enter a value, or flip offset to opposite side of the selection.

   From/To

   Select from face or to face (vertex, work plane or work point).

4. Click OK to accept and apply all of the changes to the selected bend.