Creates ribs (thin-walled support shapes) using an open or closed profile.
- Access
-
Ribbon:
3D Model tab
Create panel
Rib
Normal to Sketch Plane - Extrudes geometry normal to the sketch plane. The Thickness is parallel to the sketch plane.
Parallel to Sketch Plane - ExtrudeParallel to Sketch Planes geometry parallel to the sketch plane. The Thickness is normal to the sketch plane.
Shape
Specifies the profile geometry and sets the direction.
Profile - Selects a profile to define the shape of a rib network. Profile shapes can be open or closed.
- Solid
- Selects the participating body in a multi-body part.
Direction - Specifies the direction the geometry is extruded.
- Extend profile
- By default, the profile extends to intersect a face, if necessary. Clear the check box to prevent the profile from extending.
- Thickness
- Specifies the width of the rib or web.
-
Flip -
Applies the thickness on one side of the profile, or extends equally on both sides of the profile.
To Next - Terminates the rib or web on the next face.
Finite - Sets a specific distance for the rib or web termination. Enter a value.
Draft
Hold Thickness
- At sketch
- The specified thickness is controlled at the sketch plane.
- At Root
- The specified thickness is controlled at the intersection of the rib feature and the next face.
- Draft Angle
- Enter a value to add draft to the rib feature.
Boss
- Centers
- Selects sketch points that lie on rib profile geometry.
- Select All
- Selects all sketch points that intersect rib profile geometry.
- Diameter
- Specifies the diameter of the boss feature.
- Offset
- Specifies the distance above or below the sketch plane to start the boss feature.
- Draft Angle
- Adds draft to the boss features.