This dialog is used to specify the advanced options for the first injection unit, which controls Material A for a Co-injection Molding or Thermoplastics Bi-injection Molding process analysis.
To access this dialog, ensure that you have selected either the Co-injection Molding or Thermoplastics Bi-injection Molding process and an analysis sequence that includes Fill or Fill+Pack, click 
(), and then click Advanced options.
| Molding material | Select and edit the material to analyze. |
| Process controller | Allows you to select and edit a process controller to control the injection molding process during the analysis. You can control the filling phase, velocity/pressure switch-over point, pack/holding phase, mold temperature and mold-open time. |
| Injection molding machine | Select and edit an injection molding machine to simulate your molding machine during the analysis. You can configure the injection unit, hydraulic unit, and clamping unit. |
| Mold material | Allows you to select and edit the mold material to be used during the analysis. You can specify the density, specific heat, and thermal conductivity of the mold material. |
| Solver parameters | Allows you to select and edit the solver parameters to be used during the analysis. |