Editing occurrence number properties

The occurrence number property is supported for the following model entities:

• All runner system related entities apart from the sprue (runner, gate, overflow well).
• All part related entities (part, part surface, part beam).
• Preform surface.
• Compression surface.

The occurrence number property is not supported for:

• All Cool analysis related entities (channel, bubbler, baffle, hose, part insert).
• Core (Stress analysis used for core shift prediction does not support occurrence numbers).

Note: Occurrence numbers are supported for Fill+Pack analyses only. If you intend to also run a Cool or Warp analysis, you will need to model all flow paths explicitly.

1. Click Select.
2. Select the model sections that you want to specify an occurrence number for.
3. Right-click on the highlighted model section and select Properties. If more than one entity type was selected, the Select Properties dialog appears.
   1. Select one or more entities of the same type and then click OK.
   2. Follow this procedure to the end and then repeat from step 3 for all entity types.
4. Enter the required Occurrence number for the selected model entity or entities.
   Tip: Select the Apply to all entities that share this property check box to apply the occurrence number to all model entities with the same properties.
5. Click OK.
6. Click (Mesh tab > Mesh Diagnostics panel > Occurrence), then Show, to check that the occurrence numbers have been correctly assigned.