Editing the co-injection controller switch-over point

For Co-injection molding, you can specify when to switch from Controller A to Controller B. Controller A controls the injection of Material A (skin material) and Controller B controls the injection of Material B (core material).

In Co-injection, material A is injected, then material B is injected, and finally, material A is injected again. Therefore, you need to specify the switch from Controller A to B and the switch from Controller B back to A.

1. Click (Home tab > Molding Process Setup panel > Process Settings), or double-click the Process Settings icon in the Study Tasks pane.
2. On the Controller A Settings page, enter a percentage value in the Switch to the other controller by box, and click Next.
3. On the Controller B Settings page, enter a percentage value in the Switch to the other controller by box. The default value is 80%.
4. Click Finish.