Message Text
** WARNING 307100 ** The condition for switch to press force control is met, but the injection location is still open. Delaying the switch to force control until the injection location is closed.
Explanation
The solver cannot switch to press force control until the injection locations have been closed. This message is relevant to models with 3D meshes. Injection locations will be closed at the end of the injection packing stage. The switch to press force control will be delayed until after the packing profile has been completed.
Resolution
You can leave the settings as they are and accept that the solver will delay the switch until the injection location is closed. If you would like to eliminate the warning message, since the injection locations must be closed before the switch to force control can be performed, either
- change to a different
switch to press force control
command
- If you have selected
from the start of compression
, change the time that compression starts
- If you have selected
by time
, change the time to after the packing profile has been completed
- change the packing time in the packing profile.