This dialog is used to specify the Fill+Pack analysis related advanced options for the selected analysis sequence.
To access this dialog, ensure that you have selected an analysis sequence that includes Fill+Pack, click 
(), if necessary click Next one or more times to navigate to the Fill+Pack Settings page of the Wizard, then click Advanced options.
General settings
| Molding material | Select and edit the material to analyze. Click Edit to make changes to the selected material. |
| Process controller | Allows you to select and edit a process controller to control the injection molding process during the analysis. Click Edit to control the filling phase, velocity/pressure switch-over point, pack/holding phase, mold temperature and mold-open time. |
| Injection molding machine | Select and edit an injection molding machine to simulate your molding machine during the analysis. Click Edit to configure the injection unit, hydraulic unit, and clamping unit. |
| Mold material | Allows you to select and edit the mold material to be used during the analysis. Click Edit to specify the density, specific heat, and thermal conductivity of the mold material. |
| Solver parameters | Allows you to select and edit the solver parameters to be used during the analysis. Click Edit to configure intermediate results, mold/melt convergence criteria, and analysis restart settings. |