Using filters when modeling or meshing

Filters help you select a required model or mesh entity by automatically snapping to the nearest instance of the selected model or mesh entity when you click in the model pane.

Filters are available from a drop-down list in the dialogs related to creation (Geometry tab > Create panel) and meshing (Mesh tab > Mesh Repair panel) tools.

An appropriate subset of the filters is available in each dialog. Select one of the following filters from the drop-down list.

Any item
After selecting this mode, you can click anywhere in the model pane, including locations which are not on the model.
Modeling plane
After selecting this mode, you can click anywhere in the model pane, or on the active modeling plane to create nodes or curves.
Node
Click on a node to select it.
Nearest Node
Click on the model. The nearest existing node is selected for you.
Curve
Click on the model. The nearest existing curve is selected for you.
Center of arc
Click anywhere on an arc. The center coordinate of the circle described by the arc is selected for you.
End of curve
Click anywhere on a curve. The point at the nearest end of the curve is selected for you. This option is useful if, for example, you are using Connect Curves (Geometry tab > Create panel > Curves > Connect Curves), and it is important that you select one end of the curve rather than the other end.
Middle of curve
Click anywhere on a curve. The middle point of the curve is selected for you.
Point on curve
Click anywhere on a curve. The closest coordinate on the curve is selected for you.