Solver message 3001121

Message text

** WARNING 3001121 ** No initial stress data found. Interface will build initial stress data needed. This may take a few minutes.

Explanation

An error occurred while reading the .tsp file to get initial stress data.

Resolution

Check whether an MPI 6.0 or later version of Autodesk Simulation Moldflow Insight 3D Warp has been run in order to use this feature, or re-run the whole analysis sequence again. Check whether mesh aggregation is used for 3D Warp; the initial stress cannot be produced for aggregated mesh. MPI 6.1, and later versions of the Autodesk Simulation Moldflow Insight interface program build initial stress based on Fill+Pack results, so it may take some minutes.