** WARNING 201330 ** Stress analysis is a "small deflection" analysis. Initial displacement and residual stress inputs from warpage will not be considered.
You have selected an analysis sequence where a Stress analysis follows a Warp analysis. The predicted part deflections from the Warp analysis, and the predicted residual stresses in the part, can only be used as input for the Stress analysis if a large deflection Warp analysis was run. The Stress analysis was performed on the original part geometry.
If you would like to consider the initial displacement and residual stress inputs from a Warp analysis, select Large Deflection analysis on the Warp Settings page of the Process Settings Wizard and rerun the analysis.