CIS/2-Dateireader

Der CIS/2-Dateireader unterstützt die vom Amerikanischen Stahlbauinstitut (American Institute of Steel Construction, AISC) festgelegten CIS/2-Normen (CIMSteel Integration Standards) als Format für den Datenaustausch zwischen stahlbezogenen CAD-Programmen.

Unterstützte Elemente

  • Assembly_design
  • Assembly_design_child
  • Assembly_manufacturing
  • Analysis_model_3d
  • Part_derived
  • Part_prismatic_simple
  • Part_sheet_bounded_complex
  • Part_sheet_bounded_simple
  • Section_profile_compound
  • Section_profile_derived
  • Section_profile_edge_defined
  • Section_profile_angle
  • Section_profile_channel
  • Section_profile_circle
  • Section_profile_circle_hollow
  • Section_profile_i_type
  • Section_profile_i_type_asymmetric
  • Section_profile_i_type_rail
  • Section_profile_rectangle
  • Section_profile_rectangle_hollow
  • Section_profile_t_type
  • feature_volume_prismatic_chamfer
  • feature_volume_prismatic_flange_notch
  • feature_volume_prismatic_flange_chamfer
  • feature_volume_prismatic_notch
  • feature_volume_prismatic_skewed_end
  • Element_curve_simple
  • Element_node_connectivity
  • Element_eccentricity
  • Located_joint_system
  • Design_joint_system
  • Joint_system_mechanical
  • Fastener_mechanism
  • Fastener_simple_bolt
  • Fastener_simple_shear_connector

Nicht unterstützte Elemente

  • Part_complex
  • Part_prismatic_complex
  • Part_sheet_profiled
  • Section_profile_centreline
  • feature_cutting_plane
  • feature_edge_chamfer
  • feature_surface
  • feature_thread
  • feature_volume_complex
  • feature_volume_curved
  • feature_volume_hole
  • Element_volume
  • Element_surface
  • Element_point
  • Element_curve_complex
  • Element_with_material
  • Joint_system_amorphous
  • Joint_system_chemical
  • Joint_system_welded
  • Weld_mechanism
  • Joint_system_complex
  • Fastener_simple_nut
  • Fastener_simple_washer
  • Fastener_simple_stud
  • Fastener_simple_pin
  • Fastener_simple_nail
  • Fastener_simple_screw
  • Fastener_simple_countersunk
  • Fastener_simple_curve
  • Fastener_simple_complex

Unterstützte Schnittprofil-Grundtypen

Der Dateireader unterstützt die folgenden Schnittprofil-Grundtypen:

  • I-Träger
  • T-Profil
  • Winkel
  • U-Profil
  • Kreis
  • Rechteck
  • Doppelwinkel
  • Querbalken

Unterstützte AISC-Schnittprofiltypen

Der Reader unterstützt alle nach AISC definierten Schnittprofiltypen, und ordnet diese den Schnittprofil-Grundtypen zu:

  • I-Träger: HP, M, S, W
  • T-Profil: MT, ST, WT
  • Winkel: L, LP
  • U-Profil: C, MC
  • Kreis: HSRO, P, PX, PXX, RB
  • Rechteck: HSRE, HSSQ, SB, TS
  • Doppelwinkel: DL, DLL, DLS