This tool searches the entire model (depending on the Single Parts / Assemblies switch) for structural parts that do not have a part mark (e.g. because they were created after the numbering).
Note: Newly added objects are only get detected if the switch is set to Single Parts (
).
). To access the command?
Ribbon: Output > Part marks: 
Command line: _AstM5CommEqualPartsWithoutNum
To mark parts without numbers?
-
Output
tab,
Part marks
panel, switch to the single parts:
-
Output
tab,
Part marks
panel: Click .
- Any parts found are highlighted in red.