Repeat a Previously Created Connection

Repeats the previously executed rule for joints.

Creates a connection of the same type, but not necessarily the same parameters. During joint creation repeat the same steps as for the connection command selected from the Connection Vault .

TIp:Repeat the joint creation command as an alternative to selecting the joint from the Connection Vault again.

To access the command

Ribbon: Extended Modeling > Joint utilities:

Command line: _AstM4CrConByRule UseLastRule

To repeat the previously created connection

1. On the ribbon, select: Extended Modeling > Joint utilities > .
2. Select the elements as for the joint command selected from the Connection Vault.

• A new connection is created. The properties dialog box appears.