G Commands
Topics in this section
GCCOINCIDENT (Command)
Constrains two points together or a point to a curve (or an extension of a curve).
GCCOLLINEAR (Command)
Causes two or more line segments to lie along the same line.
GCCONCENTRIC (Command)
Constrains two arcs, circles, or ellipses to the same center point.
GCEQUAL (Command)
Resizes selected arcs and circles to the same radius, or selected lines to the same length.
GCFIX (Command)
Locks points and curves in position.
GCHORIZONTAL (Command)
Causes lines or pairs of points to lie parallel to the X axis of the current coordinate system.
GCPARALLEL (Command)
Causes selected lines to lie parallel to each other.
GCPERPENDICULAR (Command)
Causes selected lines to lie 90 degrees to one another.
GCSMOOTH (Command)
Constrains a spline to be contiguous and maintain G2 continuity with another spline, line, arc, or polyline.
GCSYMMETRIC (Command)
Causes selected objects to become symmetrically constrained about a selected line.
GCTANGENT (Command)
Constrains two curves to maintain a point of tangency to each other or their extensions.
GCVERTICAL (Command)
Causes lines or pairs of points to lie parallel to the Y axis of the current coordinate system.
GEOMCONSTRAINT (Command)
Applies or persists geometric relationships between objects or points on objects.
GRADIENT (Command)
Fills an enclosed area or selected objects with a gradient fill.
GRID (Command)
Displays a grid pattern in the current viewport.
GROUP (Command)
Creates saved sets of objects called groups.
GROUPEDIT (Command)
Adds and removes objects from the selected group, or renames a selected group.