To Add Pressure Networks to Profile Views

You can add a pressure network to a profile view by creating an alignment from the pressure network and then creating a profile from that alignment. You can also add pressure network parts that exist in plan view to an existing profile view.

After you add parts from plan to profile, if you subsequently create new parts in plan view, you need to add those parts to the profile.

However, new parts created in profile view are created in the model (so they are automatically visible in plan view also). Editing a part in either view edits the model so the change is carried through to both views.

To create an alignment from the pressure network and add the pressure network to a profile at the same time

1. Run the Create Alignment From Pressure Network command and select the Create Profile And Profile View check box in the Create Alignment From Pressure Network dialog box.
2. When you click OK, the Create Profile From Surface dialog box is displayed. Add the desired surface to the Profile list and then click Draw In Profile View .
3. In the Create Profile View wizard, on the Pipe Network Display page, verify that the pressure network parts that you want to add to the profile view are selected.
4. Click Create Profile View and select an insertion point in the drawing.

To add one or more pressure network parts to an existing profile view

1. Select one or more pressure network parts in plan view that you want to add to profile view. The Pressure Networks contextual ribbon tab is displayed.
2. On the Network Tools panel, click Draw Parts in Profile Find.
   Note: A profile and profile view must exist in the drawing in order to use this command.
3. Select the profile view to which to add the pressure network parts.