To Use Inventor Models in Mockup 360

You can create a Mockup 360 file and add a model to an existing Mockup 360 file.

Create a Mockup 360 file with an Inventor Model

1. Open a model in Autodesk Inventor.
2. On the Autodesk Inventor ribbon, click Autodesk 360 tabMockup 360 panelAdd to Mockup.
3. Log in using your Autodesk 360 credentials.

   If you do not have the local files of the Mockup 360 application installed on your computer, allow the installation to run.

4. In the Autodesk Mockup 360 dialog box:
   • Click Create New Mockup, and enter the mockup name.
   • To open the new mockup in Mockup 360, select Launch Autodesk Mockup 360 to See Mockup.
5. In the Autodesk Mockup 360 dialog box, click OK. Then click OK again to close the message box.

Add an Inventor Model to an existing Mockup 360 file

1. Open a model in Autodesk Inventor.
2. On the Autodesk Inventor ribbon, click Autodesk 360 tabMockup 360 panelAdd to Mockup.
3. Log in using your Autodesk 360 credentials.

   If you do not have the local files of the Mockup 360 application installed on your computer, allow the installation to run.

4. In the Autodesk Mockup 360 dialog box:
   • Click Add to or Update Existing Mockup, and select an existing mockup file.
   • To open the changed mockup file in Mockup 360, select Launch Autodesk Mockup 360 to See Mockup.
5. In the Autodesk Mockup 360 dialog box, click OK.
6. If appropriate, click Update in the Upload File dialog box. Then click OK to close the message box.