Allows you to assign different objects to MASH points.
Note: Should be added to the Instander's ID channel.
ID Node
- ID Type
-
The type of ID distribution. Options include:
- Linear: Increments the ID of each object by 1. Loops if there are not enough objects.
- Random: Each object gets a random ID.
- Cycle: IDs are incremented per frame.
- Fixed: Each ID is the same.
- Num. of Instancer objects
- Specifies how many object IDs to issue.
- Random Seed
- Changes the randomization when ID Type is set to Random.
- Fixed ID
- Sets a specific ID number when ID Type is set to Fixed.
Cycle Options
- Loop Type
-
Determines how animations on each object will cycle. Options include:
- Normal: The ID's animation will loop.
- Stop At End: Each ID's animation stops when the cycle runs out of objects.
- Oscillate: The ID's animation will reverse once it gets to the end of the sequence.
- Randomize Cycle Start Points
- Staggers animation start points. Does not work whenID Type is set to Random.
- Cycle Gap
- Changes the randomization when ID Type is set to Random.
- Random Start Limit
- The maximum number of frames between the first and last objects starting their cycle.
- Time Scale
- A multiplier for the current Time. Use this to fine tune calculations based on the current Time.
- Time
- Displays the current frame being used in cycle calculations.
Strength
- Strength
- Fades the node's effect for all the points at the same time.
- Random Strength
- Smoothly fades the node's effect on all the points in a random order.
- Step Strength
- Turns the node's effect off one point at a time.
- Strength Map
- Determines the input file (2D texture, animated texture, etc) that controls the shape of this node's effect.
- Map Projection Axis
- Determines the axis along which the Strength Map is projected.
- Map Helper
- Displays the object being used to interactively place the
Strength Map in the scene. You can right-click the field to create a new helper object (a plane) if none exists. You can also middle-drag a mesh into this field or right-click to connect a selected mesh. If a mesh is already connected, you can also right-click to break its connection or show it in the Outliner.
Note: For the best results, assign the same texture to both the Strength Map and the Map Helper (this automatically happens when creating a new helper object).