This dialog is used when setting up for a rapid heating and cooling analysis, using induction heating as the heat source.
To access this dialog, click on an induction coil element, then click 
(). Select Time with Target Temperature as the Induction coil control, then click Specify.
| Widget | Explanation |
|---|---|
| Switch off time |
Enter the time, following injection, at which the heater should be turned off. |
| Switch on time |
Enter the time, following injection, at which the heater should be turned on. |
| Temperature control |
This section of the dialog refers to the temperature at which the heater should be maintained, and where the temperature measurement is taking place.
|
| Cycle control |
If the mold has not reached the target temperature, you can choose to extend either the mold open or the mold close time. |